Home - The Official Formula 1 Website Skip to content

2011 rule changes - stricter floor load tests 03 February 2011

The FIA tightened up on floor load testing at last year's Italian Grand Prix, following the much-talked-about 'flexi-floor' controversy and the stricter tests have been written into the regulations for 2011. The floor is now subject to load at three different points, each 100mm apart, rather than at one central point, with a maximum permitted deflection of 5mm.

FIA Technical Regulation
3.17.5 - Bodywork may deflect no more than 5mm vertically when a 2000N load is applied vertically to it at three different points which lie on the car centre line and 100mm either side of it. Each of these loads will be applied in an upward direction at a point 380mm rearward of the front wheel centre line using a 50mm diameter ram in the two outer locations and a 70mm diameter ram on the car centre line. Stays or structures between the front of the bodywork lying on the reference plane and the survival cell may be present for this test, provided they are completely rigid and have no system or mechanism which allows non-linear deflection during any part of the test.
Furthermore, the bodywork being tested in this area may not include any component which is capable of allowing more than the permitted amount of deflection under the test load (including any linear deflection above the test load), such components could include, but are not limited to :
a) Joints, bearings pivots or any other form of articulation.
b) Dampers, hydraulics or any form of time dependent component or structure.
c) Buckling members or any component or design which may have, or is suspected of having, any non-linear characteristics.
d) Any parts which may systematically or routinely exhibit permanent deformation.